. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE NOTICE 4 - 24 Be sure to install the air cleaner element fa cing in the correc Install so that the bot tom of the air cleaner e lement cylinder (f ace where no hole is drilled) (B), (C ) is at cover (3) end. If the direction of i nstallation is mistaken, there is d anger that it will caus element or serious d 8. Replace O-ring (8) of cover (3) wit NOTICE When inserting the e lement, if the rubber at the tip is swollen or the outer element is not pushe d in straight, and cove r (3) is assemble d by force to hook (2), there is d anger that the hook a nd air cleaner body may be damaged, so be care ful when assembling. 9.
Install cover (3 ) as follows. r (3) with the element. ip of hook (2) to the protruding part of the air dy and lock it in position. 1) Align cove 2) Hook the t cleaner bo 3) When locki on opposit as when ti 4) Always ins the ground 5) When cov between th If it is too la r (3) with the elemen ip of hook (2) to th dy and lock it in posi ng hooks (2) in posit ion, apply the h ooks in turn e sides (top, bottom, left, right) in th e same way ghtening bolts. tall cover (3) so that the evacuator (4) is facing (A). er (3) is installed, check that the clearance e air cleaner body a nd cover (3) is n ot too large. rge, install again.