. MAINTENANCE MAINTENANCE PROCEDURE Mixing rate of water and antifreeze -35 -40 -31 -40 17.3 18.6 14.7 13.4 4.57 4.91 3.88 3.54 54 58 WARNING it. (Only machines equipped with corrosion resistor) 4 - 26 To maintain the anticorrosion properties of Supercoolant (AF-NAC), always keep the density of Supercoolant d 68%. between 30% an When deciding th e ratio of antifreeze to water, check the lowest temperature in the past, a nd decide from the mixing table given belo w. er to estimate and temperature about 10°C (18°F) lower when deciding the mixing ratio. depends on the ambient temperature, but it should always be a minimum of 30% by volume amount of coolant x 100).
It is actually bett er to estimate and temperatur e about 10°C (18°F) lower when deciding The mixing ratio depends on the ambient te amount of coolant x 100). (antifreeze/total Even in areas wh ere it is not necessary to prev ent freezing, use Supercoolant (AF-NAC) at a mixing ratio of at least 30% to prevent c orrosion of the cooling syste m. The freezing tem perature of undiluted antifreez e is -15°C (5°F). Do not store undiluted a ntifreeze at a temperature of below -15°C ( 5°F). Min.
atmosph temperatur eric °C Above -10 e °F Above 14 -15 -20 -25 -30 5 -4 -13 -22 Amount of antifr liter 9.6 eeze US gal 2.54 11.5 13.1 14.7 16.0 3.04 3.46 3.88 4.23 liter 22.4 20.5 18.9 17.3 16.0 ter US gal 5.92 5.42 4.99 4.57 4.23 Volume ratio (%) 30 36 41 46 50 Antifreeze is fla mmable, so keep it away from fla me. Antifreeze is tox ic. When open the drain valve, be careful not to get wate r containing antifreeze o n you. If it gets in your eyes, flush your eyes with large amount of fresh water and see a doctor at once.
When changing the coolant or draining the coola nt from the radiator before carrying out repairs, ask a specialist company to handle any coo lant containing antifreeze, or co ntact your Komatsu distributor. Antifreeze is toxic, so never pour it into d surface. drainage water ditches or drain it onto the groun Use antifreeze a nd appropriatewater for dilutin g. (for details, see "COOLANT AND WATE R FOR DILUTION (PAGE 4-5)") use of an antifreeze density gauge to control the mixing proportions. ner whose capacity is larger than the specified coolant volume to catch drained coolant. o supply antifreeze coolant and water.
We recommend use of an antifreeze density g auge to control the Prepare a contai ner whose capacity is larger t han the specified coolant volume to catch Prepare a hose t o supply antifreeze coolant a . Stop the ma chine on level ground, then st . Turn valve (1 ) of the corrosion resistor fully