Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE so inspect the Adjustment WARNING 4 - 30 CHECK AND ADJUST T Wear on pins and bushings th working con track tension every now an d then in order to maintain the sta ndard tension. For carrying out inspection and adjustment of track shoes, p ark the machin e on the flat and Checking 1. Run the engine at low id a distance equal to the t the machine. 2. Put on the track shoe st from idler (1) to upper c 3. Measure the maximum the wooden bar and top Deflection "a" should be le, then move the machine forwa rd for rack length on ground, and slowly stop 2. Put on the track shoe st raight wooden bar (3) which stretches arrier roller (2).

deflection between bottom surface of surface of the track shoe. 10 - 30 mm (0.4 - 1.2 in). If the track tension is not at the standard value, adjust it in th e following man There is danger of plug (1) flying out under the high internal pressure of the grease. Never loosen plug (1) more than 1 turn. han plug (1). Never put your face in the loosened with the procedure given here, istributor. Never loosen any part other t mounting direction of plug (1). If the track tension cannot be please contact your Komatsu d Increasing Track Tension Prepare a grease pump. 1. Pump in grease through (Grease fitting (2) forms 2. To check if the tension move the machine slow length of track on groun 3.

Check the track tension adjust it again. 1. Pump in grease through grease fitting (2) with a grease p ump. one part with plug (1).) is correct, run the engine at low idle, 2. To check if the tension ly forward (by an amount equal to the d), then stop the machine. again, and if the tension is not correct,