Komatsu — EVERY 250 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING 4 - 50 The parts and oil ar e at high temperature imme diately after the engine is stopped, and may cause s erious burns. Wait fo r the temperature to go d own before starting the op If there is still press ure remaining inside the c ase, the oil or pl ug may f ly Loosen the plug sl owly to release the pressur Prepare a handle . ark at the top, with the UP mark and plug (P) the ground surface. 1. Set the TOP m perpendicular to 2. Remove plug (F ) using the handle.

Whe n the oil level r eaches a point 10 mm ( 0.4 in) below the bottom of the plug hole, the F), operate the travel correct amount of oil has been added. 3. If the oil level i s too low, install plug ( e forward or in reverse levers, and driv to rotate the sprocket gain. procket one turn. Then r epeat Step 2 to check a 4. If the oil level is low, add oil through the hole of plug (F ). Add oil until oil overf lows from the hole of plu g (F). 9.8 Nm (7 ± 1 kgm, .2 lbft) 5. After checking, REMARK There are two plugs (F). Add oil through the one easier to fil l oil and through which no in ternal gears are to be se en.