. MAINTENANCE MAINTENANCE PROCEDURE CHECK AIR CONDITIONER COMPRESSOR BELT TENSION, ADJUST Adjustment 1. Remove guard (1). REMARK using the mounting position of bolt (2) as a fulcrum. 3. When the position of the compressor is determined, tighten 4 - 53 Checking n of the belt should be 6 to 9 mm (0.23 to 0.35 in) d with a finger force of approx. 58.8N (6 kg) at ) between the crankshaft pulley (B) and the ulley (A). The deflectio when presse mid-point (C compressor p 0.35 in) kg) at he 2. Loosen b olts (2) and (3), then mov e compressor (4) t o adjust.
When the bolt s (2) and (3) are loosened, compressor (4) ca n move, nd (3) to hold i t in positio NOTICE Check each pulley for damag e, wear of th e V-groove, and wear of the V-belt. In particular, be sure to c heck that the V-belt is not touching the bottom of the V -groove. he Komatsu distributor in your territory to replace the belts with new ones. e allowance for adjustment. ming from the belt. er one hour of operation. In case any o f the following o ccurs, ask t he Komats u distribu tor in your territory to replace the belt • The fan be lt has elongated , leaving littl e allowanc e fo r adjustmen • A cut or cr ack is found on the belt.
• Slipping o r creaking sound is heard co ming from the When the ne w V-belt is set, r eadjust it aft er one hour of