Komatsu — HYDRAULIC CIRCUIT

. ATTACHMENTS AND OPTIONS MACHINE READY FOR ATTACHMENT Adjusting Oil Flow Depending on the attachment, it is necessary to change the oil flow in the service circuit. For details of setting the oil flow, see "ATTACHMENT OPERATIONS (PAGE 6-17)". Switching Between Breaker and General Attachment If an attachment is installed as an option, and the mode is set to B mode: (1) The system is set to the breaker operation circuit (1-way circuit). (2) The hydraulic oil flowing to the breaker circuit flows to the additional filter for the breaker. (3) The relief pressure valve is set to low pressure. Set pressure when machine is shipped from factory:

17.2 MPa (175 kg/cm 2 , 2,490 PSI) (4) It is possible to use the selector mode to adjust the maximum oil flow. If an attachment is installed as an option, and the mode is set to P or E mode: (1) The system is set to the crusher operation circuit (2-way circuit). (2) The hydraulic oil flowing to the crusher circuit does not flow to the additional filter for the breaker. (3) The relief pressure valve is set to high pressure. Set pressure when machine is shipped from factory: 20.1 MPa (205 kg/cm 2 , 2,910 PSI) (4) It is possible to use the selector mode to adjust the maximum oil flow.

6 - 8 HYDRAULIC CIRCUIT NOTICE NOTICE It is ne cessary to return the re turn c ircuit direct ly to t he retur n filter when a breaker i s used, so use only the B mode . Do not use an y other mode. When the mac hine i s shipped from follow When B mode is selected: 17. 2 MPa (175 kg/cm When P or E m ode is selected : 20.1 MPa (205 k g/cm2, 2,910 P SI). The se t pressu re ma y have to be adjusted depending on the attachment. In such cases, please ask your Komatsu distributor to carr y out th e adjustment. actory , the s tandar d set pressure of the safety valve in the service valve is set as Switching Hydraulic Circ uit ttachment, set the working mode on the monitor as follows.

Depending o n the type of a ttachmen t, set the w orking mode on the monitor as follows. The s et pressure o f the safe ty valve in the s ervice valve and the hydraulic c ircuit switch is according to the working mode select ed. Attachment Working mode Hydraulic circuit Set pressure of safety valve in service valve Breaker or other attachment with one-way circuit B mode Return circuit automatically switched so that it does not pass through control valve When shipped from factory : 17.2 MPa (175 kg/cm2, 2490 PSI) Crusher or other attachment with two-way circuit P mode or E mode Return circuit automatically switched so that it passes through control valve When shipped from factory :

20.1 MPa (205 kg/cm2, 2910 PSI)