Using Fuel Injector Info Using Cylinder Cutout The Cylinder Cutout option provides a test method to locate a cylinder whose output is different from the others. This is done by cutting one injector at a time and com- paring the resulting injector pulse width to the base pulse width established before the first cylinder was cutout. This option allows you to: run a new automatic test (see ”Automatic Test”, below) run a new manual test (see “Manual Test”, on page 44) review results of a previous test (see “Review Previous Test Results”, on page 48) Automatic Test When running a test in automatic mode, the Pro-Link ® controls the entire test and displays the results as they occur.
First, the engine is allowed to run with all injectors operating. The resulting injector pulse width is recorded on the first line. The bottom line contains the engine RPM. After establishing the base pulse width, the Pro-Link ® cuts out each injector in turn. The pulse width that results for each cylinder is displayed. This process repeats until all injectors have been cut out. NOTE: i Once the test has completed, you can print out the results by pressing the Detroit Diesel Application User’s Manual 41 key on the Pro-Link® , while viewing the results.