Komatsu — BEFORE STARTING ENGINE

. OPERATION MACHINE OPERATIONS AND CONTROLS Check Oil Level in Engine Oil Pan, Add Oil WARNING the engine is stopped and may cause serious burns. Wait for the oil 1. Open the front engine hood. 2. Remove dipstick (G), and wipe the oil off with a cloth. 3. Fully insert dipstick (G) into filler pipe, then remove it. 6. If oil level is correct, securely tighten the oil filler cap and close the engine hood. REMARK When checking the oil level after the engine has been operated, wait for at least 15 minutes after stopping the engine before checking. If the machine is at an angle, make it horizontal before checking. 3 - 114 Parts temperature to go down befor e performing this operation. 4.

The oil level should be between the H and L marks o n dipstick ( I ( G). f the oil level is below the L mark, add oil through oi l filler port F). 5. I f the oil is above the H mark on the gauge, remove cove r (1), drain the excess oil fro m drain valve (P) at the engine oil pan, then ch eck the oil level again.