. OPERATION MACHINE OPERATIONS AND CONTROLS Check Coolant Level, Add Coolant WARNING of of If Check Electric Wiring CAUTION 3 - 116 Do not open the radiator cap unless necessary. When c hecking the c oolant, always wait for the e ngine to cool dow n and c heck the sub tank. Immediately after the en gine is stopped, the coolant is at a high tem perature and the radiator is under high intern al pressure. If the cap is removed to check the coolant level in this condition, th ere is a hazard of burns. Wait for the temperature to go down, then turn the cap slowly to release the pressure and remove i t carefully. 1.
Open the rear engin e hood and check that the cooling wat level is between the If the water level is sub-tank (1) to the F FULL and LOW marks on th e sub-tank ( low, add water through the water filler ULL level. , tighten the cap securely. is empty, there is probably leakage cting, repair any problem immediately. 2. After adding coolant 3. If the sub-tank (1) is empty, there is probab cting, repair any problem i coolant. After inspe there is no problem, the coolant level is l sub-tank (1). mmediately. check the coolant level in the radiator.
ow, add coolant to the radiat or, then fill t If fuses are frequently b lown or if there are traces of short-circuiti distributor to locate the cause and make the repair. Keep the top surface of the battery clean and check the breather hole in the battery cap. If it is c logged with dirt or dust, wash the battery cap to clear the breather hole. Check that there is no damage to the fuses; tha t fuses of t he specified capacity a re used; that th ere i s no disconnection or trace o f short-circuiting in the elect ric wiring an d no damage to the cove ring. Check also that t here is no loosened terminals . If any, tighten them.
r attention to the electric wiring when checking the battery, engine starting motor and ere is no inflammable material accumulated around the battery. If any is found, remove Moreover, pay particula alternator. Be sure to check that th immediately.