. OPERATION TROUBLES AND ACTIONS TROUBLES AND ACTIONS RUNNING OUT OF FUEL from the fuel circuit. Procedure for Bleeding Air CAUTION 1. Loosen air bleed plug (A) at the fuel main filter head (1). 2. Loosen wing nut (4) holding lever (3) of priming pump (2). 3. Push in lever (3) repeatedly. Check that bubbles come out with the fuel from air bleed plug (A). 4. Tighten air bleed plug (A). Tightening torque: 4.9 to 6.9 Nm (0.5 to 0.7 kgm, 3.6 to 5.1 lbft) 5. Tighten wing nut (4) securely to lock lever (3) in position. Target tightening torque: 11.8 Nm (1.2 kgm, 8.7 lbft) 6. Turn the key in the starting switch to the START position and start the engine.
When doing this, do not crank the starting motor continuously for more than 20 seconds. If the engine does not start, wait for at least 2 minutes, then try again. Perform this operation a maximum of 4 times. 7. If the engine does not start, repeat the operation from Step 1. 3 - 196 When starting the engine again after running out of fuel, fill with fuel, then bleed the air from the fuel system before starting the engine. Always watch the fuel level and be careful not to run out of fuel.
I f the engine has stopped because of lack of fuel, it is necessary to use the primin g pump to bleed the air completely This engine consists of higher precision parts than on the conventional fuel injection p ump and nozzle, so if dirt gets in, it wil cause problems. If there is any dirt stuck to the fuel line, use fuel to wash it off comple Be careful when opening the air bleed plug at the fuel filter head. The system is still u nder pressure and fuel may spurt out.