. MAINTENANCE MAINTENANCE INFORMATION Service Meter Reading Check the service meter reading every day to see if the time has come for any necessary maintenance to be performed. Komatsu Genuine Lubricants For lubrication of the machine, use the Komatsu genuine lubricants. Moreover use oil of the specified viscosity according to the ambient temperature. 4 - 2 MAINTENANCE IN Do not perform any inspecti on and maintenance operation that is not fo Komatsu Genuine Replacem ent Parts Use Komatsu genuine parts specified in the Parts Book as replacemen Windshield Washer Fluid Use automobile window was her fluid, and be careful not to let any dirt g Fresh and Clean Lubricants Use clean oil and grease.
Al so, keep the containers of the oil and greas e clean. Keep foreign materials a way from oil and grease. Check Drained Oil and Used Filter After oil is changed or filters a re replaced, check the old oil and filters for m etal particles and for eign materia ls. If l arge quantity of metal particles o suitable action. r foreign materials are found, always report to the person in charge, and carry out harge, carry Fuel Strainer If your machine is equipped with a fuel strainer, do not remove it while f Welding Instructions Cut off power. Wait for ap prox. one minute after turning off the engin e starting switch key , and then di sconnect the negative (-) terminal o f the battery.
00 V continuously. within 1 m (3.3 ft) of the area to be welded. If grounding cable is connected near etc., the instruments may malfunction. Do not apply more than 2 Connect grounding cable instruments, connectors, etc., the instruments may malfunction. If a seal or bearing happe ns to come between the part being welded a nd grounding point, change the g rounding point to avoid such parts. nd the work equipment pins or the hydraulic cylinders as the grounding point.
Do not use the area arou nd the work equipment pins or the hydraulic cylinders as the gro unding point Do not Drop Things Inside M achine When opening inspection windows or the oil filler port of the tank to carry out inspection, be careful n ot to drop nuts, bolts, or tools inside If such things are dropped lead to failure. If you drop the machine. inside the machine, it may cause damage and/or malfunction of the machine , and will anything inside the machine, always remo ve it immediately. r inspection. Do not put unnecessary t hings in your pockets. Carry only things wh ich are necessary fo r inspection. Dusty Jobsite sites, do as follows:
When working at dusty work Clean the radiator fins an d other parts of the heat exchange equipme nt more frequently, a nd take care not t o let the fins become clogged.