. MAINTENANCE MAINTENANCE PROCEDURE 4 - 46 NOTICE If the air is no t bled from the s wing motor, th e motor bear ings ma y be When replaci ng the travel mot or safety valve, please cont act your Komatsu distributor to hav e it replaced and to have t he air bled. 5. Bleeding a ir from travel m (Bleed the air only when t he oil inside t he travel m otor case h 1) Run th e engine at lo and tighten it when oil flow 2) Run th e engine at low idle and swing the wor k equipmen 90° to bring it to the si de of the track. raised slightly from 3) Jack u p the machine until the trac k is from the gro und. Rotate th e track under no load for 2 minutes.
Repea t this procedure on both the left and rig ht sides . 6. Bleeding a ir from attachm ent (when installed) I f a breake r or other attach ment has been i nstalled , run th e engine at low idle and o perate the attachment peda repeatedly (approx. 10 tim es) until the air has bee n bled f rom the attachment circu it. NOTICE If the method of bleeding the air from the attachment its elf is specified by the manufacturer , bleed the air ac cording to the specified pro cedure. After complet ing the air bleedi ng operation, s top the engi ne, and l eave the machine for 5 min utes before starti ng operations. This will rem ove the air bubble s in the oil inside the hydr aulic cylinders.
that has been spilled. Chec k that th ere is no leakage of oil and wip e of f any oil that has been After complet ing the air bleedi ng operation, i nspect the o il level, a nd i f the oil level is low, ad