. MAINTENANCE MAINTENANCE PROCEDURE CHECK WATER PUMP Since the pulley may have play, oil may leak, water may leak, contact your Komatsu distributor for inspection, overhaul or replacement. REPLACE ACCUMULATOR (FOR CONTROL CIRCUIT) WARNING a to on the right. 4 - 82 EVERY 4000 HOUR Maintenance for every 50, 250, 500, 1000 and 2000 hours serv ice should be carried out at the CHECK STARTING M Contact your Komatsu distributor to have the starting motor che cked.
If the engine is started f requently, have this inspectio n carried o ut every 10 Replace the accumulat or every 2 years or every 400 0 hours, w hichever co The accumulator is charge d with high-pressure nitrogen ga s, so mistak en operation may cause an explosio n, which will lead to serious injury or damage. When handling the accumulator, always do a s follows. The pressure in the hyd raulic circuit cannot be complete ly removed. When rem oving the hydraulic equi pment, do not stand in the direction that the the operation. oil spurts out when carrying out t he operatio n. In additio n, loosen the bolts slow ly when carrying out accumulator. e or dispose of it in fire. or weld it.
ubject it to any impact. Do not disassemble the Do not bring it near flam Do not make holes in it Do not hit it, roll it, or s When disposing of the accumulator, the gas must be re leased. Ple ase contact your Komatsu distribut or to have this work carried out. If operations are co ntinued after the performance of t ped, it will be impossible to release t accumulator has drop remaining pressure in the hydraulic circuit if there should be Please ask your Komatsu distributor r. should be failure on the machine. replace the accumulato The accumulator is inst alled to the position shown in the diagra