. OPERATION MACHINE OPERATIONS AND CONTROLS Warming-up Operation 1. Turn fuel control about 5 minutes with no load. 2. Set lock lever (2) to the FREE position, and raise the bucket from the ground. (4) 3 - 77 NOTICE When the hydraulic oil is at a low temperature , do n ot carry o ut operations or move the lever sudd enly. Always carry out the warming-up operati on. This will help to exten d the machine life. p operation is completed. Do not suddenly ac celerate the engine before the w arming-u p operatio n is Do not run the engi ne at low idling or high idl ing co ntinuousl y for more than 20 minutes.
(Oil dow n) If it is necessary to run the engine at idling, apply a load from time to time or run the engin e at a mid-range speed. After starting the eng ine, do not immediately start operatio perform the followin g operations and check ositi IDLE and run the engin e at medium s peed 3. Operate bucket control lever (3) and arm control lever slowly to move t of the stroke. he bucket cylinder and arm c ylinder t o the 4. Operate the buc ket for 30 seconds and t he ar m for 30 in turn fully for 5 NOTICE When the work equipm ent is retracted, take care that i t does no with the machine body