Komatsu — BUCKET REPLACEMENT AND INVERSION

. OPERATION MACHINE OPERATIONS AND CONTROLS Inversion WARNING 1. Place the bucket in contact with a flat surface. (B), and remove the bucket. 3. Turn the removed bucket. arm with link mounting mounting hole (2) and install. respectively. REMARK Install the O-ring into retaining hole (1) of the arm and bucket. 3 - 100 When reversing a bucket, there is the danger that the bucket tooth tip overruns the normal trajectory a nd interferes with the cab, thus causi ng a serious trouble. Pay good attenti on to the work when reversing a bucke t so that the bucket and the cab may not interfere with each other. REMARK When removing the pins, pl contact with the ground.

ace the bucket so that it is in light gly to the ground, the resistance will If the bucket is lowered stron will be increased and it will be dif ficult to remove the pins. NOTICE After removing the pins, make su re that mud or sand does not get on th em. Dust seals are fitted at both ends of the bushings, be careful not to damage them. s and nuts, then remove pins (A) and et. t. After turning the bucket, align the ole (1), then align the link with arm tall. the arm (A) and (B) into hole (1) and hole (2) When installing the bucket, th e O-rings are easily damaged, s o fit the O-rings on the boss of the arm end as shown in the diagram (3) on the right.

When knocking in the pins, move the O-ring down to nd nuts for each pin, then grease the