Komatsu — DISCHARGED BATTERY

. OPERATION TROUBLES AND ACTIONS Battery Removal and Installation (See "BATTERY INSPECTION COVER (PAGE 3-34)".) 3. Loosen wing bolt (3), then remove seat (4) installed on top of the battery. REMARK Remove the battery at the front first. Installing of Battery NOTICE 3 - 125 Removal of Battery 1. Open engine hood (1) and hood support lever. (See "ENGINE HOOD (PAG 2. Open battery inspection cov with the cover support lever. lock in position securely with the E 3-32)".) 1. 2. 1. (See "ENGINE HOOD (PAG Open battery inspection cov with the cover support lever. er (2) and lock in position securely 4. Disconnect cable (5) from th e negative (-) terminal (grounding side) first.

Disconnect connection cab positive (+) terminal. le (6) and cable (7) from the remove fixtures (9). battery inspection cover (2). 5. 6. Loosen securing nuts (8) to 7. Take out the battery through Afte r securing the battery, check tha t it does not move. If it moves, tighten it again 1. Place the battery in the spec 2. Fasten the battery firmly wit h fixtures (9) and securing nuts (8). Securing nut tightening torq 1st nut: 4.9 to 5.9 N·m (0.5 Between nuts: 58.8 to 73.5 N·m (6.0 to 7.5 kgf·m, 43.4 to 54.2 lbf 3. Connect cable (7) to the pos itive (+) terminal of the battery. 4. Connect connecting cable (6 ) first to the positive (+) terminal of the 5. Connect cable (5) to the neg 6.

Install sheet (4). 7. Close battery inspection cov