. MAINTENANCE OUTLINE OF SERVICE If there is any foreign material in the fuel tank, wash the tank and fuel system. 4 - 5 COOLANT AND WATER FOR DILU TION n of preventing corrosion as well as preventing freezing. ot an issue, the use of antifreeze coolant is essential. The coolant has the important functio n of preventing corrosion as well as preventing Even in the areas where freezing is n Komatsu machines are supplied with excellent anticorrosion, antifreeze and Komatsu Supercoolant (AF-NAC) is s Komatsu Supercoolant (AF-NAC). Komatsu S upercoolant (AF-NAC ) has cooling propertiesand can be used continuousl y for 2 years or 4000 h ours. trongly recommended wherever available.
use distilled water or tap water (soft water). or well water (hard water), contains large amounts of minerals (calcium, When diluting the antifreeze coolant, Natural water, such as a river water magnesium, etc.), and this makes it e inside the engine or radiator, it is ex exchange, so when you dilute the co than 100 PPM. asier for scale to form inside the engine or radiat or. Once sc ale is deposited tremely difficult to remove. It also causes overheating du e to poor heat olant, we recommend that you use water with an overall hardness of less ve the precautions given in the Operation and Maintenance Manual. e sure to keep it away from flame.
o water differs according to the ambient temperature. ee "CLEAN INSIDE OF COOLING SYSTEM (PAGE 4-23)". lied in premix. In this case, never add diluting water. ngine to cool before adding coolant. an overall h ardness of less When using antifreeze, always obser ve the precautions given in the Operation and Maintenanc e Manual. Antifreeze coolant is flammable, so b The ratio of Supercoolant (AF-NAC) t For details of the ratio when mixing, s Supercoolant (AF-NAC) may be supp ee "CLEAN INSIDE OF COOLING SYSTEM ( PAGE 4-23 lied in premix.
In this case, never add diluting If the engine overheats, wait for the e If the coolant level is low, it will cause overheating, and will also cause problems with c orrosion du e to air entering the coolant. GREASE d noises at the joints. under heavy-duty conditions. Always use the recommended grease and Grease is used to prevent seizure an This construction equipment is used recommend follow the change intervals and reco Manual. mmended ambient temperatures given in this O peration an d Maintenance The nipples not included in the MAINT ENANCE section are nipples used when overhauling, so th ey do not need grease.
If any part becomes stiff or generates noise after being used for a long time, grease it. hat is pushed out when greasing. noise after being used for a long time, grease Always wipe off all of the old grease t Be particularly careful to wipe off the wear of the rotating parts. old grease in places where sand or dirt sticking in the grea se would c ause CARRYING OUT KOWA (Komatsu Oil Wear Analysis) KOWA is a maintenance service that ma kes it possible to prevent machine failures and downtime. W ith KOWA , the oil is periodically sampled and analyzed . This enables early detection of wear of the machine drive parts and other problems. We strongly recommend you to use this service.
The oil analysis is carried out at actual cost, so the cost is low , and the results of the analysis are reported t ogether with recommendations which will reduc e repair cos ts and machine downtime.