. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE has been cleaned. tape used to cover the air at the top, install to the air 4 - 18 4. D irect dry c ompressed air (Max . 0.69 MPa (7 kgf/cm 2, 99.4 P di a SI)) from t he inside of the outer element along its folds. Then rect the co mpressed air from th e outside along the fold s, and gain from t he inside. the element which has been cleaned 6 times ut a year. red immediately after the even when it has not been element. 1) Replace repeate dly or used througho 2) If the d ust indicator shows element cleaned has been cleaned, 6 times, replace the 3) Remove one seal from the el ement whenever the el ement 5.
If small hole s or thinner parts are found on the elemen t when it th is checked by shining a light thr ough it after cleaning, r eplace e element . NOTIC E When cleaning th e element, do not hit it o r beat it against somethi Do no t use an ele ment whose folds or ga sket or seal are damaged Wrap unused ele ment and store them in a dry place. 6. R onnector in side the air cleaner 7. In stall clean ed element (4) or a n 8. S et the arro w mark on cover (3 cl eaner bod y, then secure with c