Komatsu — CHECK, CLEAN AND REPLACE AIR CLEANER ELEMENT

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 4. Direct dry compressed air (Max. 0.69 MPa (7 kgf/cm 2 , 99.4 same time. has been cleaned. NOTICE 4 - 20 OTICE he inner ele T r eplacing the outer element, replac e the inner elemen t at the same time. m the inside of the outer element al ong its folds. Then e compressed air fr om the outside a long the fold s, and m the inside. lace any outer ele ned 6 s or used for 1 year .

Replace the in ner element at the lace both inner and outer elements when the du st indicator red piston appe ars soon after installin g the ned outer element even though it h as not been cleaned 6 ove one seal from the element whe never the el ement 5. If small holes or thinner pa rts are found on the elemen t when it is chec the elem ked by shining a lig ht through it afte r cleaning, r eplace ent. When cleanin g the element, do not hit or beat it agai Do not use an element whose folds , gasket or seal ar 6. Set the cleaned outer elem ent (4) in positio