. MAINTENANCE MAINTENANCE PROCEDURE CLEAN INSIDE OF COOLING SYSTEM WARNING *: Permanent type antifreeze shall meet the requirements of ASTM D3306-03. Stop the machine on level ground when cleaning or changing the coolant. The coolant has the important function of preventing corrosion as well as preventing freezing. Even in the areas where freezing is not an issue, the use of antifreeze coolant is essential. Komatsu machines are supplied with Komatsu Supercoolant (AF-NAC). Komatsu Supercoolant (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for 2 years or 4000 hours. Komatsu Supercoolant (AF-NAC) is strongly recommended wherever available.
To maintain the anticorrosion properties of Supercoolant (AF-NAC), always keep the density of Supercoolant between 30% and 68%. 4 - 23 Immediately after th e engine is stopped, th e coolant is at a high temperatur e and t he radiator is under high internal pressure. If th e cap is r emoved to drain th e coolant in this condition, t here is a hazard o f burns . Wait for t he temperature to g o down , then turn the cap slowly t o release t he pressure before removin g it. Cleaning is c arried ou t wit h the engine runn ing.
When standing u p or leaving the op erator's seat, set the lock lever to the LOCK position For details o f starting the e ngin e, see "BEF ORE STARTING ENGI NE (PAGE 3 -54)" a nd "STARTIN G ENGINE (PAGE 3-71)" in the OPERATION section. The engine i s operate d when w ashing, so i t is dangerous if the m achine moves wh en you are standing behind it.
Never stand behind t he machine when the engine is ru Clean the inside of th e cooling system, c hange the coolant according to the table below Antifreeze coolant Interval of cleaning inside of cooling system and changing antifreeze coolant Komatsu supercoolant (AF-NAC) Every two years or every 4000 hours whichever comes first Permanent type antifreeze (All-season type, *) Every year (autumn) or every 2000 hours whichever comes first