Komatsu — REPLACE HYDRAULIC OIL FILTER ELEMENT

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE ENGINE (PAGE 3-71)" and run the engine at minutes. REMARK 4 - 70 7. Remove bolts (4), then r emove cover (5). W hen this is done, the c over may fly off und er the force of sprin g (6), so keep the cove r pushed down whe n removing the bolts 8. After removing spring (6 ) and valve (7), take out e lement ( 8). 9. Clea n the rempved part 10. Insta ll the new element where old element (8 ) wa s installe Inspe ct the O-ring set b etween the hydrauli c tan (5). I f there are any scr atches, replace the O -ring 11. Set v alve (7) and spring (6) on top of the element 12.

Set c over (5) in positio n, hold it down by h and, an cove r mounting bolts (4) 13. Insta ll the cap of oil filler 14. Move (2). 15. Clos 16. To bl "STARTING for 10 17. Stop Wai t for a t least 5 minutes a fter stopping the eigine to eliminat e bubbles in the oil inside th 18. Chec k for oil leakage an d wipe off any spille d oil.