Komatsu — CHANGE OIL IN HYDRAULIC TANK, CLEAN STRAINER

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 4 - 76 5. Open mud cover (1). e plate (3) to the outside. 6. Loosen bolts (2), then remov 7. Remove the cap from oil fill pressure. er (F), and release the internal 8. Place a container under the d machine underside. Then r handle, and drain oil. At that time, check the O-ri replace it with a new one, if draining oil, tighten drain plug Tightening torque of the drain Take care not to get oil on plug (P). Place a container under the d machine underside. Then r handle, and drain oil.

At that time, check the O-ri replace it with a new one, if rain plug which is located on the emove drain plug (P), using a ng fitted to drain plug (P) and any damage is found on it. After (P) again. plug: 68.6 ± 9.81 N·m (7 ± 1 kgf·m, 51 ± 7 lbft) draining oil, tighten drain plug Tightening torque of the drain Take care not to get oil on yourself when you remove drain 9. Remove bolts (4), then remo ve cover (5). When this is done, the cover may fly off under th e force of spring (6), so keep the cover pushed down when re moving the bolts. 10. Pull up the top of rod (7), the (8). Remove any dirt from straine or flushing oil.

n remove spring (6) and strainer r (8), then wash in clean light oil ce it with a new part. 11. If strainer (8) is broken, repla 12. When installing, insert straine r (8) into tank protruding portion (9), and assemble. Set cover (5) in position, ho ld it down by hand, and tighten stall cover (5). the cover, and if it is damaged, 13. cover mounting bolts (4) to in Check the O-ring installed to replace the O-ring. 14. Add the replacement amount of oil through oil filler (F). Check that the oil level is between gauge. the H and L lines on the sight For details of oil level check, s ee "Check Oil Level in Hydraulic Tank, Add Oil (PAGE 3-59)". ucket cylinder fully as shown in 15.

Extend the boom, arm, and b the diagram on the right, rem ove the oil filler cap, then install side of the tank. the cap and pressurize the in 16. Move plate (3) to the center (2). Close cover (1). of the cap, then secure with bolt nd cleaning or replacing filter element and strainer, bleed air from the circuit. 17. 18. After replacing hydraulic oil a nd cleaning or replacing filter element and strainer, bleed air f For details of the method of bl eeding the air, see "BLEEDING AIR FROM HYDRAULIC SYS TEM (PAGE 4-48)" NOTICE Be s ure to pressurize the hydraulic ta nk. If it is not pressurized, the pump will suck in air, and this will adversel y affect the equipment.