. ATTACHMENTS AND OPTIONS MACHINE READY FOR ATTACHMENT HYDRAULIC CIRCUIT NOTICE air bleeding procedure for the 6 - 7 Hydraulic Circuit Connection When c onnecting the attachment, connect the hydraulic circuit as 1. Check that the stop valve is at the LOCK position, then remove the plug. Be careful not to lose or damage any part that is removed. 1. Check that the stop valve is at the LOCK position, then remove the plug. Be careful not to lose or dama ge any part that is removed. 2. Connect the piping for the attachment maker. attachment provided by the he The dimensions on the stoppe r valve side are as indicated at right.
For those on the attac manufacturer of attachment a hment side, confer with each nd determine. 3. Afte 1) r connecting the piping, bl Start the engine, referring eed the air from the circuit. to "STARTING ENGINE (PAGE 2) 3-71)", and run it at low idle for the subsequent 10 minutes. Then proceed to the next work. e until the air in the attachment 2) Run the engine at low idl circuit is completely remov pedal repeatedly (approx. ed, then operate the attachment 10 times) to bleed the air. I f th e at attachment itself, follow the specified 3) After completing the blee ding of the air, stop the engine, and wait for at least 5 min utes before starting operations.
This will release the bubbl es in the oil inside the tank. 4) Check that there is no oil l eakage, and wipe off any oil that has been spilled.