Komatsu — CONTROL PATTERN CHANGE PROCEDURE

. ATTACHMENTS AND OPTIONS CHANGING MACHINE CONTROL PATTERN (IF PATTERN CHANGE VALVE EQUIPPED) CHANGING MACHINE CONTROL PATTERN (IF PATTERN CHANGE VALVE EQUIPPED) WARNING 3) After the switching, tighten wing bolt (1). 6 - 13 When changi ng the operating pattern of th e machine, set the machin e in the parking posture, stop t he engine, check th at the safety lock le ver is at the LOCK position, t hen change the operating pattern. T o prevent pe rsonal injury caused by mista ken operation, test operate the machine and check that th e display on the ope rating pattern card i s the same as the movement of the machine. pattern card immediately with the card that matches the operating pattern.

ine, check carefully that the surrounding area is safe, and operate slowly. If it is not the same, replace the operating pattern card immediately with the card that matches the When checkin g the movement of the mach ine, check carefully that t he surrounding area is safe, an CONTROL PATTERN CHANGE P ROCEDURE 1. After setting the machine in the parking posture, set the lock lever to the LOCK position, then stop the engine. 2. Open the inspection cover on the left side of the machine. The selector valve is inside. 1. After settin g the machine in the park ing posture, set the lock lever to the LOCK position , then stop the en gine. 2.

Open the in spection cover on the left side of the machine . Th selector va 3. Follow the steps explained below, when switching th wing bolt (1). a new operation pattern with a notch on lever ( patterns. 1) Loosen 2) Select en move lever (2) downw a dark triangular mark (" 4. Change to an operating pattern card (insert it in the holder) that matches the selected o perating pattern. 5. Start the e ngine, set the lock lever to the FREE position, operat e the work equipment le vers slowly, and c heck t hat the op erating pattern has chang ed.