Komatsu — SWITCHES

. OPERATION DETAILED CONTROLS AND GAUGES OPERATION DETAILED CONTROLS AND GAUGES REMARK Swift Deceleration Switch WARNING 3 - 16 The position. Make sure first that the lock lever is in the LOC K position, and then turn t he engine starting swi Fuel Control D ial used to control engine speed and output. sition: The dial is turned to the left (counterclockwise) fully. osition: The dial is turned to the right (clockwise) fully. This dial (2) is used to control engine speed and outpu (a) Low idle po sition: The dial is turn (counterclockw (b) High idle p osition: The dial is tur fully.

REMARK When the swift deceleration monitor i s lighted up, the en gine speed will remain at low idling even if the dial is operated. To restore engine speed , press swift decelera tion switch on th e left work tion. ork equipment con trol lever to cancel the deceleration func Always return th e work equipment and tr avel levers to the ne utral position before operating the swift deceleration switch. If the switch is operat ed when any lever is bein g operated, the engi ne torque will suddenly change.

This switch (3) is used to activate the system to lower t he engine speed and reduce the fuel consumption when the engine output is not required, such a s when the travel levers, travel pedals and work equip ment control levers are at th e neutral position. When the swif t deceleration switch in the center of the knob of the left work equip ment control lever is p ressed, the swift d eceleration monitor lights up and the engine spe ed goes down to l ow idling. When the s wift deceleration swit ch is pressed again, the he engine speed turns to the again, deceleration m onitor goes off, and t he fuel control dial. speed set by t