. OPERATION DETAILED CONTROLS AND GAUGES of the machine, and inspect or replace. REMARK Power may be sourced from the cigarette lighter, too. For the details, see the section of "Cigarette Lighter (PAGE 3-19)" in this manual. CONTROLLERS NOTICE Do not let water, mud, or juice spill on the controller. This will cause failures. If any problem occurs in the controller, do not repair it by yourself. Please contact your Komatsu distributor for repairs. The controller is installed behind the operator's seat.
3 - 36 FUSIBLE LINK switched on even when the starting switch is position, there is probably a disconnection in pen the battery inspection cover on the left side If th e power is not turn fusib ed to the ON le link (1), so o position, there i pen the battery i s probab nspection ly a disconnec cover on the l A fusible link refer high current flow s to the large-sized fuse wiring installed in the portion of the circuit to protect electrical wiring from burning, in the same way as an high portion of th components and ordinary fuse. rotect el ectrical AUXILIARY ELECTRIC POW NOTI Whe make maximum of 240 W (1 0 A or equivalent).
When installing electrical equipment with a larger capacity, plea se consult your Komatsu distributor. An optional conne ctor (No. K17) is fastene d to a cable with an adhesive tape at t he rear part of th e cab's fl oor. This is for taking out power for opti Komatsu. If use of such elec connector after pe onal electrical equipment made by other than trical equipment becomes necessary, use the eling the tape off. The connector typ es are shown in the table below. X type housing (2-terminal) Body Rear holder Terminal Rear holder AVS 0.5 - 1.25 AVS 2 - 3 Komatsu part No. 08055-00212 08055-00230 08055-00040 08055-00041