SYSTEM / Control System Hydraulic Oil Temperature Auto-Warming Up Control Purpose: Automatically warms up the hydraulic system. Engine Speed (similar to the auto choke on automobiles) Operation: 1. For 12 minutes after the engine starts or when hydraulic oil temperature is below 0 ° C, MC sends the signals equivalent to the target engine speed to ECM by using CAN communication according to the signals from key switch and hydraulic oil temperature sensor. 2. ECM increases the engine speed to the hydraulic oil temperature auto-warming up speed. IMPORTANT:
MC selects the higher target engine speed control; hydraulic oil tem- perature auto-warming up control or radiator coolant temperature auto-warming up control. MC sends the signal to ECM by using CAN communication. IMPORTANT: When adjusting the auto-idle speed, deactivate the hydraulic oil tem- perature auto-warming up control by using Dr. ZX. Wait for adjust ment until hydraulic oil temperature be- comes beyond 2 ° C and radiator coolant temperature becomes be- yond 50 ° C after the engine is com- pletely warmed up. The hydraulic oil temperature auto-warming up control can be de- activated temporarily by Dr. ZX.
Once the key is turned OFF, the hy- draulic oil temperature auto-warming up control is effective again. IMPORTANT: Hydraulic oil temperature auto-warming up speed can be ad- justed by Dr. ZX. Fast Idle 1400 min -1 Hydraulic Oil Temperature Auto-Warming Up Speed Increasing Speed Slow Idle Slow Idle Fast Idle Engine Control Dial Position T2-2-16