SYSTEM / Control System Speed Sensing Control Purpose: Controls the pump delivery flow rate in re- sponse to engine speed changes due to variations in load so that the engine output power can be utilized more efficiently. Engine stall is prevented when the machine oper- ates under adverse conditions such as op- erating at high altitude. Operation: 1. The target engine operating speed is set by con- trolling the engine control dial. 2. MC calculates the difference in speed between the target engine speed and the actual engine speed monitored by CAN communication from ECM. Then, MC sends the signals to the torque control solenoid valve. 3.
The torque control solenoid valve delivers pilot pressure in response to the received signals to the pump regulator and controls the pump deliv- ery flow rate. 4. If the engine load increases and the actual engine speed becomes slower than the target engine speed, the pump swash angle is reduced so that pump flow rate will be reduced. Therefore, the engine load is reduced and engine stall is pre- vented. 5. If the actual engine speed becomes faster than the target engine speed, the pump swash angle is increased so that pump delivery flow rate will in- crease. Therefore, the engine output power can be utilized more efficiently. Q Flow Rate Pump P-Q Curve P Pressure T2-2-28