SYSTEM / Control System Travel Motor Swash Angle Control Purpose: Controls the travel mode. Operation: Slow When the travel mode switch is in the SLOW position, the travel motor swash angle is kept in the maximum angle so that the travel speed is slow. Fast 1. When the travel mode switch is in the HIGH position and MC receives the signals from travel pressure sensor, pump 1 and 2 delivery pressure sensors and pump 1 and 2 control pressure sensors under the following conditions, MC shifts solenoid valve unit (SI). 2.
When solenoid valve unit (SI) is shifted, pilot pressure acts on the travel motor swash angle control valve and reduces the swash angle to the minimum, so that the travel speed increases. Condition: Travel Pressure Sensor: Outputting signal Front Attachment Pressure Sensor: OFF Pump 1, 2 Delivery Pressure Sensors: Delivery pressure of either pump is low. (Reference: 24 MPa (245 kgf/cm 2 , 3490 psi) or less) Pumps 1, 2 Control Pressure Sensors: Either pump control pressure is high. (Reference: 2.2 MPa (22 kgf/cm 2 , 320 psi) or more) NOTE: When one side track is raise off the ground and is rotated, the one side pump control pressure increases, so that the raised track rotates at fast speed.
When the machine is traveling in the fast speed and even if the front attachment is operated (the front attachment pressure sensor: ON), the travel mode is kept in the fast speed. T2-2-52