SYSTEM / Hydraulic System BOOM LOWER METER-IN CUT CONTROL Purpose: During combined operation of boom lower and arm, bucket, swing or travel with the front attachment above the ground, pressure oil to the boom cylinder from the pump is cut, the boom falls due to own weight by using the regenerative circuit, pressure oil is used for other actuators and the control speed increases. Operation: Boom Cylinder Bottom Pressure: High Pressure (with the front attachment above the ground) 1. During combined operation of boom lower and other actuators with the boom raised, the boom lower meter-in cut valve is shifted by the boom cylinder bottom pressure.
As boom lower pilot pressure does not act due to the boom lower meter-in cut valve, the boom 2 spool does not move. 2. The boom flow control valve (switch valve) is closed by boom lower pilot pressure. 3. Back pressure in the boom flow control valve (poppet valve) increases and the boom flow control valve (poppet valve) is closed. 4. Pressure oil to the boom 1 spool from pump 1 is cut by the boom flow control valve (poppet valve). 5. Pressure oil in the boom cylinder bottom side flows to the boom cylinder rod side through the boom 1 spool due to boom own weight. 6. As all pressure oil from pumps 1 and 2 is used for actuators except the boom, the control speed increases. T2-4-24