COMPONENT OPERATION / Pump Device REGULATOR The regulator controls the main pump flow rate in response to the various command signal pressures so that the pump driving power does not exceed the engine power. Pump 1 and pump 2 are provided with one regulator for each. The major parts of regulator are spring (1), sleeve A (2), sleeve B (8), spool A (3), spool B (7), piston (4), load piston 1 (5), load piston 2 (6), inner spring (9) and outer spring (10). According to the various command signal pressures, the regulator opens or closes the circuit to servo piston (11), the inclination of cylinder block (12) is changed and the pump flow rate is controlled.
4 2 1 3 5 Dr Pi Pd1 Air Bleeding Circuit Pps Dr Pd2 NOTE: Pilot oil pressure is constantly supplied in the smaller chamber side of servo piston (11). Dr 7 8 Pg T1V1-03-01-005 Pd1 -Pump 1 Delivery Pressure Pi - Pump Control Pressure 11 Increase Decrease 13 Cylinder Block Inclination Pd2 -Pump 2 Delivery Pressure Pps -Torque Control Pressure Dr - Returning to Hydraulic Oil Tank Pg - Primary Pilot Pressure (From Pilot Pump) 1 - Spring 8 - Sleeve B 2 - Sleeve A 9 - Inner Spring 3 - Spool A 10 - Outer Spring 4 - Piston 11 - Servo Piston 5 - Load Piston 1 12 - Cylinder Block 6 - Load Piston 2 13 - Link 7 - Spool B T3-1-6 9, 10 6