COMPONENT OPERATION / Pump Device Increasing Flow Rate 1. When the pump load is reduced, either pump 1 delivery pressure Pd1 or pump 2 delivery pressure Pd2 decreases. (During operation, pump control pressure Pi is kept increased.) 2. Load piston 1 (5), load piston 2 (6) and spool B (7) are pushed by inner spring (9) and outer spring (10). Spool B (7) moves toward direction of the arrow. 3. Due to the movement of spool B (7), the circuit from the large chamber of servo piston (11) is opened to the hydraulic oil tank. 4. As pilot pressure is constantly routed in the small chamber of servo piston (11), servo piston (11) is moved toward direction of the arrow.
The cylinder block is rotated in the maximum inclination direction and the pump delivery flow rate increases. 5. The movement of cylinder block is transmitted to sleeve A (2) via link (13). Sleeve A (2) is moved in the same direction as spool A (3). 6. When sleeve A (2) is moved by the same stroke as spool A (3), the open part between spool A (3) and sleeve A (2) is closed and pilot pressure to servo piston (11) is blocked. Therefore, servo piston (11) is stopped and the flow rate increasing operation is completed.
Flow Rate (Q) Pressure (P) 0 5 Pi Pd1 Air Bleeding Circuit Pps Dr Pd2 Dr 7 Pg T1V1-03-01-005 11 13 Increase Decrease Cylinder Block Inclination 2 - Sleeve A 9 - Inner Spring 3 - Spool A 10 - Outer Spring 5 - Load Piston 1 11 - Servo Piston 6 - Load Piston 2 13 - Link 7 - Spool B Pd1 -Pump 1 Delivery Pressure Pi - Pump Control Pressure Pd2 -Pump 2 Delivery Pressure Pps -Torque Control Pressure Dr - Returning to Hydraulic Oil Tank Pg - Primary Pilot Pressure (From Pilot Pump) T3-1-16 3 Dr 2 9, 10 6