COMPONENT OPERATION / Swing Device Operation Output Curve: Between A and B (When relieving) 1. When releasing the control lever, the spool in control valve moves to the neutral position. As the swing motor rotates due to the inertia force of machine, pressure in the circuit at port BM (return side) increases momentarily and operates the swing relief valve. 2. Pressure oil from port BM acts on combination valves (A, B) respectively. Operation of Combination Valve (A): 3. Pressure oil acting on combination valve (A) opens ball (2) and flows to chamber N through poppet (1). 4.
When pressure in chamber N is larger than spring (4) force and spring (7) force (pressure in chamber N > spring (4) force + spring (7) force), piston (5) tries to move to the left. However, pis- ton (5) is blocked by the plug and cannot move. 5. Plunger (3) and poppet (1) pushes springs (4, 7) and move to the right in union. This state continues until pressure at port BM be- gins to decrease (output curve: between B and C). Operation of Combination Valve (B): 6. Pressure oil acting on combination valve (B) flows to the spring (4) chamber through the inner pas- sage. 7.
When pressure in spring (4) chamber is larger than spring (4) force and spring (7) force (pres- sure in spring (4) chamber > spring (4) force + spring (7) force), plunger (3), piston (5) and pop- pet (1) compress springs (4, 7) and move to the left in union. This state continues until pressure at port BM de- creases (output curve: between C and D). Pressure at Port AM Pressure (P) A B C D E Time (T) T1V1-03-02-001 Pressure at Port BM Pressure (P) Without Combi- nation Valve Time (T) T1V1-03-02-002 T3-2-12 Wi A B tio C D E Wi tio th Combina- n Valve