COMPONENT OPERATION / Swing Device Output Curve: Between B and C (Pressure begins to decrease) When the swing motor rotation due to the inertia force of machine is reduced, pressure at port BM decreases. At this time, combination valve (A) functions as the following. Operation of Combination Valve (A): 1. When pressure at port BM decreases, pressure acting to chamber N also decreases. 2. When pressure in chamber N becomes smaller than the spring (4) force, the spring (4) force moves plunger (3) to the left. 3. At the same time, poppet (1) is pushed to the left by the spring (7) force. 4. As the pressure difference due to orifice (6) ap- pears, pressure in chamber M increases. 5.
Therefore, poppet (1) moves to the left more slowly. 6. Consequently, the clearance between poppet (1) and plunger (3) appears. Pressure oil from port BM flows to port AM through the clearance be- tween poppet (1) and plunger (3). 7. As combination valve (A) makes pressure oil in port BM (high-pressure) flow to port AM (low-pressure), pressure increase at the high-pressure side is controlled and aftershock pressure is reduced. This state continues until aftershock pressure at port AM appears (output curve: between D and E).
Pressure at Port AM Pressure (P) A B C D E T1V1-03-02-001 Time (T) Pressure at Port BM Pressure (P) Time (T) T1V1-03-02-002 Without Combi- nation Valve T3-2-14 With Combina- tion Valve Wi A B tio C D E Wi tio