hitachi — Main Relief Valve

COMPONENT OPERTATION / Control Valve MAIN RELIEF VALVE The main relief valve serves so that pressure in the main circuit does not exceed the set pressure when the actuator such as motor or cylinder is in operation. Thus, oil leak from hose and pipe joints and breakage of the actuator are prevented. Relief Operation 1. Pressure in port HP (main circuit) acts to the pilot poppet through orifice A in the main poppet and orifice B in the seat. 2. When pressure in port HP reaches the set pressure by spring B, the pilot poppet opens, pressure oil from passage A flows along the external circumference of sleeve and flows to port LP (hydraulic oil tank). 3.

At this time, a pressure difference is caused between port HP and spring chamber due to orifice A. 4. When this pressure difference reaches the set pressure by spring A, the main poppet opens and pressure oil from port HP flows to port LP. 5. As a result, the pressure in main circuit decreases. 6. When pressure in the main circuit decreases to the specified level, the main poppet is closed by the force of spring A. Set Pressure Increasing Operation 1. When pilot pressure from solenoid valve unit (SG) acts to port SG, spring B is compressed by the piston. 2. Therefore, the force of spring B becomes strong. 3.

Consequently, as pressure required in order to open the pilot poppet is increased, the relief set pressure is increased. T3-3-28