hitachi — Regenerative Valve

COMPONENT OPERTATION / Control Valve ARM REGENERATIVE VALVE During Normal Operation: 1. During normal arm roll-in operation, return oil from the cylinder rod side flows to chamber B through notch (C) on the arm 1 spool. 2. Return oil is divided from chamber B. One flows to the hydraulic oil tank through notch (A) on the arm 1 spool. The other flows to the hydraulic oil tank through the hole (orifice) on the spool in arm regenerative valve. 3. As pressure at the cylinder bottom side is larger than that at the cylinder rod side, the check valve is kept closed. 4.

Consequently, as pressure oil at the cylinder rod side does not flow to the cylinder bottom side, the regenerative operation is not operated. During Regenerative Operation: 1. When solenoid valve unit (SC) is activated by the signal from the main controller (MC), pilot pressure shifts the spool in arm regenerative valve. (Refer to Control System/ SYSTEM.) 2. Pressure oil from chamber B (the cylinder rod side) is blocked by the spool in arm regenerative valve. 3. As pressure oil flows to the hydraulic oil tank from chamber B by only the circuit through notch (A) on the arm 1 spool, pressure in chamber B increases. 4.

Pressure at the cylinder rod side becomes larger than that at the cylinder bottom side. 5. Consequently, pressure at the cylinder rod side opens the check valve, is combined with pressure oil from pump 2 together and flows to the cylinder bottom side. 6. The regenerative operation is operated in the procedures above and speed of cylinder increases. During Regenerative Operation: Arm 1 Arm Regenerative Valve A Chamber B Hole Spool Return Oil from Arm Cylinder Rod Side Pilot Pressure from Solenoid Valve Unit (SC) To Arm Cylinder Bottom Side Check Valve Spool C T1V1-03-03-075 T3-3-34