COMPONENT OPERTATION / Control Valve FLOW RATE CONTROL VALVE The flow rate control valve is provided in boom, arm, bucket and auxiliary circuits, restricts oil flow rate in the circuit during combined operation and gives priority to other actuators. Each flow rate control valve is operated during combined operation as shown below. Arm Cylinder Switch Valve Poppet Valve Check Valve Hydraulic Oil Tank Pressure Oil from Pump 2 T1V1-03-03-049 NOTE: The arm 1 flow rate control valve is explained here. Normal Operation Arm Cylinder Switch Valve 1. Pressure oil from pump 2 acts to the check valve in poppet valve. 2.
As the switch valve is usually kept opened, pressure oil from pump 2 opens the check valve flows to the arm 1 spool. 3. If load at the actuator side is high, the poppet valve is open and pressure oil from pump 2 flows to the arm 1 spool. 4. Therefore, flow rate through the arm 1 spool increases and speed of arm increases. Flow Rate Control Operation Poppet Valve Hydraulic Oil Tank Pilot Pressure from Signal Control Valve Pressure Oil from Pump 2 1. The switch valve in arm 1 flow rate control valve is shifted by pilot pressure from the arm 1 flow rate control valve spool in signal control valve. 2.
Therefore, back pressure in the poppet valve increases and the force to close the poppet valve appears. 3. Consequently, the poppet valve restricts flow rate to the arm 1 spool and pressure oil is supplied to the swing side which load pressure is higher at.
T1V1-03-03-050 Boom Flow Rate Control Valve Pressure Oil from Pump 1 Pilot Pressure from Signal Control Valve From Boom 2 Spool Poppet Switch Valve Boom Cylinder T1V1-03-03-076 T3-3-38 Flow Control Valve Combined Operation Boom Boom Lower (operation with the front attachment above ground (high pressure at bottom side)) Arm 1 Swing and Arm Roll-In Arm 2 Swing, Boom Raise and Arm Roll-In Bucket Boom Raise and Arm Roll-In Auxiliary Front Attachment and Auxiliary