hitachi — Parking Brake

COMPONENT OPERATION / Travel Device PARKING BRAKE The parking brake is a wet-type multi disc brake. The brake is a negative type so that it is released only when the brake release pressure oil is routed into the brake piston chamber. The parking brake is automati- cally applied unless the travel function is operated. The friction plates and plates are splined to the hous- ing in travel motor and rotor respectively. Releasing Brake 1. When the travel lever is operated, pressure oil from the main pump is routed to port AM or BM in the travel motor through the control valve. 2.

This pressure oil shifts the counterbalance valve spool in travel brake valve and acts on the brake piston through the notch on spool. 3. Consequently, as the brake piston is pushed, the plates and friction plates become free each other so that the brake is released. Applying Brake 1. When the travel lever is returned to neutral, the counterbalance valve spool in the travel brake valve is returned to neutral. 2. As pressure oil acting on the brake piston is re- turned to the drain circuit from the orifice of brake piston, the brake piston is slowly pushed back by the disc spring. 3.

Consequently, spring force is applied to the plates engaging on the outer diameter of rotor and the friction plates engaging on the inner diameter of motor housing via the brake piston, and the rotor outer diameter is secured by friction force. T3-5-6