GENERAL / Component Specifications HYDRAULIC COMPONENT PUMP DEVICE Drive Gear Ratio ............................................ Main Pump: 1, Pilot Pump: 1 MAIN PUMP Type ............................................................... Bent-Axis Type Variable Displacement Axial Plunger Pump Maximum Flow Rate ......................................174 L/min (45.9 US gpm) Ч 2 HP Mode: 191 L/min (50.4 US gpm) Ч 2 Maximum Flow Rate (Theoretical Value).......86.8 L/min (22.9 US gpm) Ч 2 Rated Pressure .............................................. 34.3 MPa REGULATOR Type ...............................................................
Hydraulic Pressure Operated Type PILOT PUMP Type ............................................................... FS 11/16.8 Model ............................................................. Fixed Displacement Type Gear Pump Maximum Flow (Theoretical Value)................ 33.6 L/min (8.87 US gpm) HP Mode: 37.0 L/min (9.76 US gpm) CONTROL VALVE Type ............................................................... Pilot Pressure Operated Type (4-Spools + 5-Spools) Main Relief Set-Pressure ............................... Normal: 34.3 MPa (350 kgf/cm 2 , 4980 psi) at 80 L/min (21.1 US gpm) Power Digging:
36.3 MPa (370 kgf/cm 2 ) at 80 L/min (21.1 US gpm) Overload Relief Set-Pressure ........................ 37.2 MPa (380 kgf/cm 2 , 5410 psi) at 50 L/min (13.2 US gpm) (Boom Lower, Arm Roll-In, Bucket Roll-In) 39.2 MPa (400 kgf/cm 2 , 5690 psi) at 50 L/min (13.2 US gpm) (Boom Raise, Arm Roll-Out, Bucket Roll-Out) SWING DEVICE Type ............................................................... Two-Stage Reduction Planetary Gear Reduction Gear Ratio..................................... 17.53 SWING MOTOR ZX160- 3 class: Model ............................................................. M5X130CHB-10A-48A/300-92 Type ...............................................................
Swash-Plate Type, Fixed Displacement Axial Plunger Motor ZX180- 3 class: Model ............................................................. M5X130CHB-10A-47A-330-99 Type ............................................................... Swash-Plate Type, Fixed Displacement Axial Plunger Motor T1-3-5