hitachi — Hose Rupture Valve

COMPONENT OPERATION / Others (Upperstructure) HOSE RUPTURE VALVE The hose rupture valve is installed to boom cylinder (bottom side circuit), arm cylinder (rod side circuit) and positioning cylinder (2-piece boom) (rod side circuit). When the hose of front attachment is damaged, the hose rupture valve holds the front attachment and prevents the front attachment from falling. NOTE: The hose rupture valve in boom cylinder is explained here. Control Lever: In Neutral 1. As pilot pressure Pi does not act on spool (2), spool (2) is pushed to the right by the spring (10) force. 2. One holding pressure of cylinder at port B acts on poppet (6) and the other acts on spool (2) through passage C (9). 3.

Holding pressure through passage C (9) is blocked by spool (2). Although pressure oil in the spring (5) chamber also acts on spool (2) through passage A (4), pressure oil is blocked by spool (2) and does not flow to passage B (8). 4. Therefore, poppet (6) is pushed downward by force (pressure of the spring (5) chamber + spring (5)). 5. Consequently, as holding pressure at port B is blocked completely, the front attachment is held and prevented from falling when the hose of front attachment is damaged.

5 9 4 External Force 6 Port B Port A 2 8 10 To Spool in Control Valve (To Hose of Front Attachment) T1V1-03-07-018 2 - Spool 8 - Passage B 4 - Passage A 9 - Passage C 5 - Spring 10 - Spring 6 - Poppet T3-7-6