hitachi — Engine Control

SYSTEM / Control System Engine Control Dial Control Purpose: Controls the engine speed according to the rotation angle of engine control dial. Reduces the engine speed by 100 min -1 in order to reduce fuel consumption and noise level when all the control levers are in neu- tral. Engine speed is reduced by 100 min -1 when the control levers are in neutral. Engine Speed Operation: 1. MC sends the signals equivalent to target engine speed to ECM by using CAN communication ac- cording to rotation angle of the engine control dial. 2. ECM controls the engine speed according to CAN communication. 3.

When the engine control dial is in the fast idle speed position and all the control levers are turned to the neutral position (pressure sensors (travel, front attachment): OFF), MC sends the signal to ECM by using CAN communication after one second. 4. ECM reduces the engine speed by 100 min -1 from fast idle speed (P mode engine speed). Engine Control Dial Position Slow Idle Fast Idle NOTE: The engine speed is reduced from the fast idle speed (P mode engine speed) by 100 min -1 . For example, when the engine speed set by the engine control dial is already slower than the fast speed idle by 100 min -1 , the engine speed does not change.

This control is done regardless of whether the auto-idle control is done or not. The fast idle speed (P mode engine speed) of engine can be corrected by Dr. EX. IMPORTANT: The control in operation steps 3, 4 is deactivated by Dr. EX temporarily or permanently. T2-2-6