Isuzu — 6-3 Operation of the cargo bed

HANDLING OF SPECIAL EQUIPMENT 2. Depress the clutch pedal, and put the dump control lever in the UP position. 3. Slowly release the clutch pedal. This causes the bed to go up. Pulling the dump control lever towards the UP position increases the rising speed. The bed stops automatically when it reaches the uppermost position. Before operating the dump control complete stop, apply the parking brake fully and keep the brake pedal depressed to the floor with lever, bring the vehicle to a WARNING the right foot. 1. Fully apply the parking brake, put the transmission shift lever in the neutral position, and start the engine.

- 6–3 - Raising the bed OPERATION OF THE CARGO BED When raising or lowering the bed, ensure that the area is clear of people or obstacles around or operating the dump control lever. Always park the vehicle on a flat ground to raise or lower the bed. Before operating the dump control lever, bring the vehicle to parking brake fully and keep the Never operate the dump control lever while the vehicle is in Never operate the bed while parked on a slope as it may brake pedal depressed to the WARNING above the vehicle before cause the vehicle to roll. a complete stop, apply the floor with the right foot. motion.