Isuzu — 7-18 Periodic maintenance

(7) Depress the clutch pedal fully and turn the key switch to "START" position to start the engine at the same time the glow plug indicator light goes off. It is strongly advisable to use an Isuzu genuine fuel filter assembly for replacement. If the engine does not start, repeat the steps (4), (5), (6) and (7). (8) Immediately after rev-up, put your hand off key and your foot off accelerator pedal. (9) Allow the engine to idle for 5 min. CAUTION With air in fuel system, smooth flow of fuel into the engine is interrupted and to prevent this bleeding of the fuel system should be performed. (1) Operate hand pump until it becomes hard to push (about 15 pushes).

(3) Operate hand pump until it becomes hard to push (about 10 pushes). (5) Operate hand pump until it becomes hard to push (about 5 pushes). (6) When the key switch is turned to "ON" position, the glow plug indicator light comes on and goes off after approx. 4.0 to 7.0 seconds (with cold engine). Please notice the glow plug indicator light does not turn on when the engine already warm (coolant temperature above 25 ° C). - 7–26 - (2) Wait for 1 min. (4) Wait for 1 min. SERVICE AND MAINTENANCE 3. Lightly oil the O-ring. Install and screw in the filter assembly clockwise carefully to prevent fuel spillage. Turn it until the O-ring is fiitted against the sealing face of the filter cover.

Further turn the filter assembly 1/3 to 2/3 of a turn with a filter wrench . If the fuel tank has been emptied, the chance is that air might have been allowed into the fuel system. BLEEDING OF FUEL SYSTEM CAUTION