GLOSSARY GLOSSARY Table 6. 28 All information subject to change without notice. Copyright © 2016 DETROIT DIESEL CORPORATION DDC-SVC-MAN-0019 Alarm An alarm mounted in the engine compartment used to alert persons in the immediate area that the engine is about to start. Active Light A dash--mounted light, labeled Idle Management, located on the right side of the dash cluster indicates that Optimized Idle is arming (flashing light) or that the system is active (Light glowing steady). Amber Warning Lamp (AWL) A panel mounted yellow indicator light. Provided by the vehicle OEM as standard. Continuous Run Condition Allows the engine to run continuously under extreme outside temperature.
Comfort Zone The number of degrees (Celsius or Fahrenheit) from the Optimized Idle thermostat set point before the interior temperature is low or high enough to indicate that the engine needs to heat or cool the vehicle. The larger the comfort zone, the longer the time between thermostat mode engine starts. Example: The thermostat is set in the heat mode at 68°F (20°C), with the comfort zone at 4°F (2°C). The engine will start when the temperature reaches 64°F (18°C) and run until the temperature reaches 68°F (20°C). CPC2 The CPC2+ is the interface between the MCM2 and the vehicle/equipment for engine control and manages other vehicle/ equipment functions.
Cruise Master Switch The main switch used to turn on cruise control. This switch is also used to turn on Optimized Idle. Detroit DiagnosticLink ® Used for diagnostic purposes. Contains DDEC Reports to analyze the data collected and stored by the CPC. ECM Electronic Control Module Engine Mode Allows Optimized Idle to stop and restart the engine to maintain the engine temperature between factory set limits and keep the battery charged.