Komatsu — AFTER RUNNING OUT OF FUEL

. OPERATION TROUBLESHOOTING TROUBLESHOOTING PROCEDURE FOR BLEEDING AIR CAUTION air a 3 - 125 AFTER RUNNING OUT If you have run out of fuel, ad d fuel to the fuel tank and bleed air from the fuel system a The fuel injection pump and n ozzle of this engine consist of more p recise parts than the conve ntional ones. If foreign matter enters them, it can cause a tr ouble. Accordingly, if dust sticks to t he fuel system, wash it off w When opening the air bleedin g plug at the fuel filter head, take care . Fuel may spout because o 1. Fill the fuel tank with fuel . (1) at the fuel main filter head. 2. Loosen air bleeding plug 3.

Do not loosen the plug a it is loosened, air is not b Loosen wing bolt (3) whi (2). Move lever (4) up t the filter stand of the fuel prefilte led. ch is fixing lever (4) of priming pu and down to let fuel flow out of 4. bleeding plug (1) until bu Tighten air bleeding plug bbles do not come out any more. (1) and then tighten wing bolt (3 y to lock lever (4). ir bleeding plug gm} ing screw .3kgm} ng switch to the START position priming pump (2) securel Tightening torque for a 7.8 to 9.8Nm{0.8 to 1k Tightening torque for w 6.9 to 12.7Nm{0.7 to 1 priming pump (2) securel Tightening torque for a 5. Turn the key in the starti start the engine.

When doing this, do not crank the starting motor continuou for more than 20 seconds . If the engine does not start, wait at least 2 minutes, then try again. Perform this operatio maximum of 4 times. 6. If the engine does not sta rt, repeat the procedure from Ste