. MAINTENANCE SERVICE PROCEDURE CLEAN INSIDE OF COOLING SYSTEM WARNING *1: When using Komatsu Supercoolant (AF-NAC), there is no need to use a corrosion resistor. When no corrosion resistor is used, use the special cover (600-411-9000). Please consult your Komatsu distributor about the method of installing. When using corrosion resistor, use Komatsu genuine corrosion resistor. If you use another corrosion resistor, it may cause serious problems such as corrosion of the engine and parts of the cooling system that use light metals such as aluminum. The coolant has the important function of preventing corrosion as well as preventing freezing.
Even in the areas where freezing is not an issue, the use of antifreeze coolant is essential. Komatsu machines are supplied with Komatsu Supercoolant (AF-NAC). Komatsu Supercoolant (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for 2 years or 4000 hours. As a basic rule, we do not recommend the use of any coolant other than Komatsu genuine supercoolant (AF-NAC). If you use another coolant, it may cause serious problems such as corrosion of the engine and parts of the cooling system that use light metals such as aluminum.
To maintain the anticorrosion properties of Supercoolant (AF-NAC), always keep the density of Supercoolant between 30% and 68%. When deciding the ratio of antifreeze to water, check the lowest temperature in the past, and decide from the mixing table given below. It is actually better to estimate and temperature about 10 ° C (18 ° F) lower when deciding the mixing ratio. The mixing ratio depends on the ambient temperature, but it should always be a minimum of 30% by volume (antifreeze/total amount of coolant x 100). Even in areas where it is not necessary to prevent freezing, use Supercoolant (AF-NAC) at a mixing ratio of at least 30% to prevent corrosion of the cooling system.
The freezing temperature of undiluted antifreeze is -15 ° C (5 ° F). Do not store undiluted antifreeze at a temperature of below -15 ° C (5 ° F). 4 - 27 Immedi ately after t he engine is stopp ed, the engine coolan t is hot and the pressure inside the radiator is high. Removing the cap an d draining th e water under this condition could caus e burns. Allow the engine to cool down , the n turn the cap slowly to relea se the press ure. Start th e engine and flush t he system. When standing up or leaving the operator's seat, set the gear s hift l ever to the N position and set the parking brake switch to t he PARKING position.
For det ails of starti ng the engine, se e "OPERATIONS, CHE CKS BEFORE STARTING (PAGE 3-86)" and "STARTING ENGINE (PAGE 3-88)" in the OPERATION sect ion of the Operation a nd Maintenanc e Manual When t he undercov er is removed, th ere is danger of touchi ng the fan. Never g o to the fron t of th e machine when the engine is run Stop the machine o n level ground w hen cleaning or ch anging the coolant. Clean the inside of t he cooling syst em, change the coo lant according to the t able below.
Inter Antifreeze coolant val for cleaning inside of cooling system and changing antifreeze coolant Precautions for use Komatsu supercoolant E (AF-NAC) very two years or every 4000 hours whichever comes first 1*