Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE and LOW marks. CHECK LEVEL OF WINDOW WASHER FLUID, ADD FLUID Carry out this check if there is air in the window washer fluid. Check the level of the fluid in window washer tank (1), and if it is 4 - 29 3. Place containers to catch the coolant under drain valve (3) at the bottom of the radiator and drain plug (4) at the side face of the cylinder block. n plug (4), and drain the water. Open drain valve (3) and drai 4. After draining the water, clos e drain valve (3) and drain plug (4), and fill with tap water. 5. When the radiator is full, start the engine, and run it at low idle.

Keep the engine running at l ow idle for 10 minutes until the ore than 90°C (194°F). water temperature reaches m 6. Stop the engine, open drain v alves (3) and drain plug (4), and drain the water. After drainin g the water, close them. 7. Replace the corrosion resisto r, then set valve (1) to the OPEN position to open it. For replacing corrosion resistor, see "REPLACE ARTRIDGE (PAGE 4-63)". reeze until it overflows from the CORROSION RESISTOR C 8. Add coolant mixed with antif water filler. Decide the proportions of antif reeze and water according to the table for the mixing rate of wa ter and antifreeze. in the coolant, run the engine at 9.

To remove the air contained low idle for 5 minutes, then ru n for a another 5 minutes at high idle. (When doing this, leave the water filler cap OFF.) 10. Stop the engine. About 3 min utes later, supply city water up to the water filler, then close rad iator cap. 11. Drain the cooling water from in side subtank (5), flush the inside of the subtank, then fill with w ater to a point between the FULL ow, fill with automobile window w Be careful not to let dirt or dust g When operating at below freezing point, use fluid with antifreeze.