. MAINTENANCE SERVICE PROCEDURE REPLACE CORROSION RESISTOR CARTRIDGE WARNING of water from the filter seal 4 - 63 All th e engine parts are at high temperature aft er the engi ne has been operated, so never replace the cartridge immediately after finishing operations. Wait for the oil to cool down before replacing t he cartridg Prepare a filter wr 1. Set valve (1) at th e top of the corrosion resistor t o the CLOSED position, to close 2. 3. 4. Set the containe Using a filter wre Clean the filter h cartridge with cle r to catch the water u nch, remove cartridg older, coat the steel an engine oil, then i 5.
l When installing, surface of the filt tighten until the g er holder, then tighte asket contacts n a further 2/3 the turns If the filter cartri damaged and thi dge is tightened too s will lead to leakage far, the of water. If gask the f et wil ilter i l be s too oose, water will also leak from the gap at the gasket, so always tighten the corre 6. Set valve (1) to t he OPEN position to open 7. After replacing t he cartridge, start th heck that surface. If there is any leakage of wa ter, check the ti ghtening of the filter cartridge.