Daewoo Commercial Vehicle DE/DV Series — Daewoo Commercial Vehicle DV-0 — user manual

2. CIRCUIT DIAGRAM BY SYSTEMS 7) FAULTCODES / REPAIR INSTRUCTIONS 108 2. n Check modulator wires. Inlet(EV) or outlet(AV) or common wire is permanently or temporarily broken or shorted to plus respectively ground. 3. n Amplitude of sensorsignal is to low. Check bearing play, polewheel run out, push sensor to polewheel. Check sensor wiring and connectors for intermittent contact. Other possible reason:gear engaged at slippery conditions. 16 sec. slip duration. 4. n Check sensor wiring. Open circuit, short circuit to plus respectively ground or between sensorwires IG/IGM is detected 5. n Check sensor wiring and connectors for intermittent contact. Check toothed wheel for damages.

Check for mismatch-fault of another sensor. Pneus or number of polewheel teeth are different. 6. n Check polewheel for damages/missing teeth/run out. Use WABCO sensor probe. Replace polewheel if not checked o. k. If additional airgap faults are stored, adjust airgap. 7-1 ECU with PROP : Check wire and speedometer signal. C3/B7 signal calibration, check tyre sizes. Gear switch signals neutral or is manipulated. Electronic engine control: Check wiring respectively other ECU's Excessive slip / dynotester ? One axle was much faster than other? 7-2 Check wire. Output wire is interrupted or grounded or shorted to battery supply. 7-3 Check wire.

Output wire is interrupted or grounded or shorted to battery supply. ECU with SAE J1922 resp. SAE J1939:Check other ECU's. No access to the link 7-4 Check wire and bulb. Was blinkcode switch activated longer than 16 s? 7-5 Check wires resp. parametersetting. Diff-brake valve without engine control is detected or CAN, PWM, PROP are detected while selfparameterizing is disabled. 7-6 Check wire. Output wire is interrupted or shorted to ground or battery supply. 7-7 Check brake sensor wiring. Intput wire is interrupted or shorted to ground or battery supply. 8-1 Check supply wire and fuse. Supply voltage is temporarily too low 8-2 Check alternator and battery.

Supply voltage too high for more than 5 sec. 8-3 Replace ABS(ASR) electronic if fault detection repeats. 8-4 No modulators connected or wrong ECM or wrong parameterized 8-5 Check ECU ground wires and common modulator wires