Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Hydraulic pump

UEN00099-00 10 Structure, function and maintenance standard PC240 Function q The pump converts the engine rotation trans- mitted to is shaft to oil pressure and delivers pressurized oil corresponding to the load. q q Piston (6) carries out relative movement in the axial direction inside each cylinder chamber of cylinder block (7). q It is possible to change the discharge amount by changing the swash plate angle. q Cylinder block (7) seals the pressurized oil to valve plate (8) and carries out relative rotation. q This surface is designed so that the oil pres- sure balance is maintained at a suitable level. q Cylinder block (7) is supported to shaft (1) by spline (14).

Structure q The oil inside the respective cylinder chambers of cylinder block (7) is suctioned and dis- charged through valve plate (8). q Shaft (1) is supported by front and rear bear- ings (15). q Tip of piston (6) is shaped as a concave ball and shoe (5) is caulked to it to form one unit. q Piston (6) and shoe (5) constitute the spherical bearing. q Rocker cam (4) has flat surface (A), and shoe (5) is always pressed against this surface while sliding in a circular movement. q Rocker cam (4) conducts high pressure oil to the cylinder surface (B) with cradle (2), which is secured to the case, and forms a static pres- sure bearing when it slides. 10 PC210, 230, 240-8